2.4.- Condition of contour of the Dump Body

It is considered the Dump Body totally embedded in the four points; the two support points and the points where the lifting cylinders are located, like it is shown in the figure N°5.

FIGURE N° 5 Border conditions applied in the support points of the Dump Body.

3.- Obtained results

According to the carried out analysis, considering all the previously described variables, the following results were obtained:

Efforts and mechanical pressures on the lateral sides and their components

The efforts obtained on the laterals are quite low according to the acceptable effort of the material, this reaches a maximum value of 30Kg / mm².

FIGURE N° 6 Efforts and mechanical pressure distributed on the Dump Body lateral sides

Efforts on the front and its components

The efforts obtained on the front are observed in the figure N¼7, it shows the maximum efforts ton the components of the front, is also under the acceptable value of effort resistance of the material, reaching a maximum value of 35 Kg / mm².